Exfo MaxTester Series Manuale Utente Scaricare il pdf

P/N: 1064921 November, 2013 1/8

NOTICE

This information applies only to the

MaxTester Series units.

Replacing Batteries

Your unit uses a lithium-polymer battery that has been especially designed

for EXFO. For this reason, you can only replace the main battery with a

battery designed for your MaxTester unit.

You can purchase new batteries from EXFO.

WARNING

Do not throw batteries into fire or water and do not short-circuit

the battery’s electrical contacts. Do not disassemble.

WARNING

 To avoid serious injuries as well as irreparable damage to your

unit, ALWAYS TURN OFF YOUR UNIT (shutdown mode, not

suspend) and DISCONNECT IT FROM THE AC POWER.

 Be careful not to drop metal objects such as screws inside the

unit. These could cause a short-circuit leading to a fire or an

explosion.

CAUTION

Electrostatic discharge (ESD) damage can cause complete or

intermittent equipment failures.

 Always use an ESD-preventive wrist or ankle strap when

handling the unit while it is open. Ensure that the antistatic

strap makes good skin contact and that the end of its wire is

grounded properly.

 All the components that you should be handling are identified

in the procedure hereafter. Do not touch any other component

inside the unit either with tools or your fingers.

 To avoid damaging the new battery, handle it with care.

CAUTION

Ensure that no foreign object falls inside the unit. This may cause

irreparable damage to your unit.

1 2 3 4 5 6 7 8

Sommario

Pagina 1 - Replacing Batteries

P/N: 1064921 November, 2013 1/8NOTICEThis information applies only to theMaxTester Series units.Replacing BatteriesYour unit uses a lithium-polymer ba

Pagina 2 - Top screws securing the

P/N: 1064921 November, 2013 2/8To replace the main battery:1. Press and hold the On/Off button a few seconds until the unit beeps once to put it in sh

Pagina 3

P/N: 1064921 November, 2013 3/86. If necessary, remove the stand so that it does not fall when you open the unit’s casing later:6a. Release the stand

Pagina 4 - Bottom screws securing the

P/N: 1064921 November, 2013 4/87. Using the provided hex key (“Allen” key), remove the two bottom screws that secure the back of the unit in place.8.

Pagina 5

P/N: 1064921 November, 2013 5/89. Using a screwdriver, remove the two screws securing the retaining plate of the battery in place. 10. Remove the reta

Pagina 6 - IMPORTANT

P/N: 1064921 November, 2013 6/812. Hold the battery by its sides and pull it up carefully.13. Place the new battery into your unit so that its cable i

Pagina 7

P/N: 1064921 November, 2013 7/815. Place the retaining plate back over the battery, ensuring that the holes for the screws are well-aligned with those

Pagina 8

P/N: 1064921 November, 2013 8/819. Using the provided hex key (“Allen” key), put back the screws securing the back of the unit in place.Note: If you h